Non-conductive double sided adhesive tabs
Non-conductive double sided adhesive tabs
1- #71-002112 Lift-N-Press double sided
premium
adhesive tabs
Ø12.5mm,
non-conductive.
2- 2 #71-002118Micro-Tec D12 double sided
non-conductive adhesive tabs
Non-conductive double sided tabs are useful for AFM, LM and SEM applications where conductivity is not a first required. We offer two types of non-conductive sticky tabs:
- Lift-N-Press adhesive tabs, non-conductive
- Micro-Tec D12 adhesive tabs, non-conductive
Lift-N-Press double sided non-conductive premium adhesive tabs
The Lift-N-Press double sided non-conductive premium adhesive tabs consists of a thin film of strong adhesive with a diameter of approximately 12.5mm. They provide excellent adhesion, even on “difficult” surfaces. To use: lift the tab of the backing sheet , press the sticky surface to the mount, then peel back the tag leaving the adhesive behind. The tabs can be cut to the desired size before removing from the backing sheet. The adhesive can be easily removed with isopropanol or acetone. Excellent adhesion to smooth surfaces of metals, plastics, glass, paper, and small particles or fibers. Compatible with Ø12 and Ø15mm AFM discs, Ø12mm mica discs, Ø12.7mm SEM pin stubs, Ø12.2mm JEOL stubs and Ø15mm Hitachi stubs. The benefits of these original Lift-N-Press premium adhesive tabs are:
- High strength thin adhesive (50µm) combined with high tack
- Smoother surface for better particle detection
- Longer shelf life and lower outgassing
- Supplied on a roll
Micro-Tec D12 double sided non-conductive adhesive tabs
are easy use and cost-efficient Ø12mm self sticking tabs are easy use and cost-efficient Ø12mm self sticking tabs. Use the protective tag to lift of the sheet and to press on the sample stub. Then lift-off the protective tag exposing the sticky surface to mount the sample. Adheres to smooth surfaces of metals, most plastics, glass, paper etc. Useful for mounting samples for AFM, LM and SEM. Supplied on a sheet.
Compatible with Ø12 and Ø15mm AFM discs, Ø12.7mm SEM pin stubs, Ø12.2mm JEOL stubs and Ø15mm Hitachi stubs.
Ordering information for Lift-N-Press adhesive tabs, non-conductive
|
|
